Forging flange production process

Forging Flange production process:


The following are the same as the :

1. Upsetting upsetting is the original blank along the axial forging, so that the height reduced, cross-section increased operation. This process is commonly used for forged gear blanks and other disc-shaped forgings. Upsetting is divided into all upsetting and partial forging rough.

2. Pulling and pulling is the length of the blank to increase the cross-section of the forging process, usually used to produce shaft parts rough, such as lathe spindle, connecting rod and so on.

3. punching punch with a punch on the blank out of the hole or not through the hole forging process.

4. A forging process in which the blank is bent into an angle or shape.

5. A forging step of twisting a portion of the blank at an angle relative to the other.

6. Cut the forging process of cutting the blank or cutting the material head.

The following are the same as the "
1. Die forging the basic process forging process: cutting, heating, pre-forging, the final forging, red with skin, trimming, quenching and tempering, shot peening. Commonly used process upsetting, pulling long, bending, punching, forming.

2. Common forging equipment commonly used forging equipment forging hammer, hot forging presses, flat forging machines and friction presses.

In layman's terms, the quality of the forged flange is better, usually through the forging production, crystal organization fine, high strength, of course, the price is also more expensive.